PRISMA – MULTISURFACE URETHANE PRIMER

Read all installation instructions thoroughly before installation.

• PRISMA may be applied by brush, roller, pad applicator, or airless spray. Use a high quality nylon brush or a ¼” – ½” synthetic nap roller cover.
• Do not thin.
• Do not apply when surface, air, or product temperature is below 35 °F.
• Do not paint in direct sun or on a hot surface. If possible, plan your painting to avoid rain, moisture, or high humidity for the first 24 hours of curing. Stop application a minimum of two hours before rain or dew is expected. Do not paint if surface temperature is within 5 °F of the dew point.

When top coating with two component paints, allow 24 hours dry time before painting. Always test questionable substrates such as plastics, composites, Kynars, and polyester surfaces by applying a small area for adhesion and top-coat compatibility before proceeding with the entire job.

Airless Spray

Tip range between .013 and .017. Total fluid output pressure at the tip should not be less than 2200 PSI. Preferred pressure is 2500 PSI.

Clean Up

Clean brushes, rollers and other equipment with warm, soapy water immediately after use. If dry, clean with lacquer thinner.

USE COMPLETELY OR DISPOSE OF PROPERLY dry empty containers may be recycled in a can recycling program. Local disposal requirements vary; consult your sanitation department or state-designated environmental agency on disposal options.

• Product is ready to use. Mix well before application.
• Do not dilute with any other material.

PRISMA is ready to receive POLICRETE epoxy mortar when it is dry over 60-90 minutes.